|
|
|
Quick Release Figure 8 Cock Ring
[EC340]
|
$11.00
Rating: 
|
|
Hold Your Erection Longer This all rubber erection enhancer is simple and easy to use. Used to hold erections harder and longer. Also can provide additional sexual stimulation. The quick release attachment opens easily to go around the cock and balls. The second ring goes around just the penis. Large ring is 2 inches in diameter, smaller ring is 1.5 inches. Rubber material makes it easy to clean.
Note: Be careful not to get lube on the connector that holds the cock ring together. If that occurs this product will unlock when undesired. |
|
|
|
|
| Viewing 1 of 1 Reviews |
|
| [Rated 4 of 5 Stars!] by Moggie |
Date Added: Friday 15 July, 2005 |
|
|
|
While this perhaps isn't the best cock-and-ball ring set sold at XR, it is customizable (compared to solid or metal rings) and very inexpensive, so if you've been wanting to try something like this, this might be a good first choice! It may be a bit hard from the photo to tell exactly what is going on, or what to expect...what part of it is the quick release? (Probably you, once you set it up and find that you like it!) A few hints and tips about the "Quick Release Figure 8 Cock Ring"... When you open the package you are two hollow rubber black tubes joined at the cuff that binds them together (loosely, you can slide the tubes through the junction) and each tube has a double-ended flanged connector at one end. For most men a test fit will prove it loose, and that's good...because you will want to trim it down with scissors until the tube length is pleasant when connected as loops. Be careful to only trim a bit at a time! You can always cut off more but can't exactly back up if you make it too tight to fasten. The tubes are stretchy but not too much, so you want shorten the tubes to make them tight enough to do what you want them to do, but not too short so you have difficulty connecting the ends. I'd also recommend sliding the tubes through the collar until the join is near the collar and to one side, so it's easier to access the joins. Another hint might be to do both up (once you have "fitted" them to your desired size) and then slide both up your cock, then slip your balls through the larger loop one at a time, might be easier once you have the fit where you want to keep it. For being both inexpensive and customizable for fit, this simple device I gave 4 out of 5 (good.) Some assembly required, but a good value. (ps I haven't had this around lube but I speculate you would want to keep the open tube clear of it or you might have a hard time keeping it joined...another argument for leaving the loops closed when putting it on, once fitted.) |
|
|
|
|
|
|
|
|
|
|
My Account
Cart Contents
Info
Add to wishlist
Tell a friend
eXtreme dollars-- you'll earn $0.55
